Friday, February 7, 2014

Printed Some Wobbly Chess Bases

I made it back to the Makerspace after a few weeks off.  Tonight, I took a spool of white PLA filament and printed five (5) bases for the wobbly chess pieces.  This took about 2.5 hours and was all the time I had tonight.

I'll take the pieces home and glue them to the top pieces that I printed before.  I need to figure out a good weight to put in the base to make them stand up.  The Thingiverse instructions says to put in five pennies.  I'm going to try lead from Pinewood Derby cars.

No comments:

Post a Comment