Advertisement

Friday, November 8, 2013

Started Second Tardis

I started 3D printing a second Tardis. Now that I know what I am doing on the 3D printer at the Makerspace, they are coming out much better.  This time, I am printing the sides with 90% infill to make them stronger.  

As you can see from the picture, the blue filament ran out after the first print so I switched to green.  They will all get spray painted navy blue when all the pieces are printed.

I hope to put electrical wiring in this Tardis to make it light up.

By the way, these three pieces took a bit over nine hours to print.

No comments:

Post a Comment